how to care your carburetor

Carburetor has a very vital role for your vehicle. If treatment is not good, then the motor is likely to be fussy and can not work when you drive. For that cleaning the carburetor, at least three months. Because if often can be overhauled to make quick bolt worn. Then, how do I clean it?

1. Clean the air filter / dust collector
Remove the air filter attached to the mouth of the carburetor, remove the foam filter and clean it with cleaning fluid, then let it dry itself. Do not be cleaned by high pressure air spray, because it can cause damage to the pores of the foam filter.

2. Clean carburetor
Open the carburetor by removing the bolts fastener, close the carburetor, choke valve / choke, tap the gasoline. Use the appropriate keys for these tools is not easy dol. Remove the carburetor components and place in a container that contains a cleaning fluid, let's easy to use liquid fuel. Remove the bowl of the carburetor, a float and float needle, main jet, pilot jet, and others. Beware of the small parts and seals / rubber protector, place in a container that can be easily seen, so that later when the installation is not confused look.
If you've cleaned off all the carburetor with a brush, then spray the holes with high pressure air. Use fine sandpaper to clean the dirt on adjusting screw,Not too much, because it can cause changes spuyer diameter. Once clean, reinstall the adjusting screw. Use a screwdriver and spuyer not too hard, just use two fingers on the tip of a screwdriver.

3. Set the float height
Before reinstalling the components of the carburetor, do not forget to adjust the height using the gasoline gauge shove / skeetmat.

4. Raft carburetor
Reinstall the carburetor parts that had been removed. Raft the carburetor and air filter with a paired back on the hole machine. Then set kongdisi slow motor on the machine state of life. Set the wind-wind spuyer by turning it clockwise outrigger stuck, then play through a few rounds in accordance with the standard engine or motor condition us.
Set the slow adjustment bolt located on the edge of carburetor body. Set in an ideal state of the engine heat. Suits do not get too low engine speed or slow, this can cause the oil can not be increased because it is not pumping due to low engine rpm.